Important issues of safety, the stability and structural strength of the swing. Looking swings that are structurally sound and provides more material per stroke board than most saws on the market.
Make sure all the hardware on a swing is lowered, so that no rough or sharp exposed edges that can hurt your children. Depth hardware should not be covered with plastic caps, such as ASTM considers this to be a choking hazardhazard.
Swing ropes should be UV protected, double braided rope woven tighter in order to reduce stretch and to retain it's strength over time. Yellow color retracts harmful UV rays that can cause dry rot damage. For added strength and safety, use 1/2-inch rope vs. smaller 3/8-inch rope that many manufacturers select. Some manufacturers use a heavy-grade wire wrap to hold the rope, which could come loose or scratch your child.
Research manufacturers who use 4" x 4" posts to support heavy-duty deck framing. If you do decide to purchase a Redwood swing set, for comparable stability, make sure to look for 4" x 6" or even 6" x 6" posts with steel bracing. Railing Strength & Spacing: All upper deck railings should be sturdy enough to support a child or adult who is leaning on the railing. Spindles should be vertical to prevent children from climbing up on the railing plus the spacing between spindles should not be wide enough to entrap a child's head.
Look for access ladders that provide non-slip strips which can be adhered to each step to make it even safer. Be wary of swing sets which use round wooden dowels or steel rungs. Access ladders can be very slippery, especially when wet from rain, snow and other climate conditions.
Ensure there are no sharp edges on swing sets and that all surface sanded so they are smooth to the touch.
Sun Shading Canopies provide protection from the suns harmful rays. Most of the wing sets comes with a canopy, tarp or wooden roof standard. This contributes to exposure to the suns harmful UV rays decrease as children play outside on your swing. In addition, the space under the deck, an additional port of the sun. Whether it is the use of the picnic table or play in the sandbox a break from the sun and the shade is always welcome.
Find splinter proof climbing frame, since they give the highest security and stability and too little protectionHands from splinters. Looking for climbing frame that is powder coated steel rungs. Wooden dowels, no matter how smooth the purchase, include age, cracks, splinters and wear. Powder coating also offers a hard surface, which is of durable and scratch resistant.
To avoid accidents, to avoid children and young people to remember climbing on the climbing frame and never the climbing frame, if the children swinging on the swing.
Many manufacturers of swings are members of theAmerican Society for Testing and Materials (ASTM), and some of these companies have contributed to the residential development of security standards for swings that are used today by both the ASTM and Consumer Product Safety Commission (CSSC).
Protective surface treatment should be, as nearly 60% is used for all injuries caused by falls to the ground. The provision of a protective pad under and around all playground equipment is the most critical factor for the safety of playgrounds. Certain manufacturedPlastic surfaces are also acceptable, however, the test data on shock absorbing performance should be requested by the manufacturer. Do not install, your swing set over concrete, gravel, asphalt, packed earth or any other hard surfaces. Asphalt and concrete are unacceptable. You do not have any damping properties. Grass and lawn should not absorb as its ability to shock during a fall are used can be reduced through wear and environmental conditions.
A fall zone covered with a protective surface materials, is essential under and around equipment where a child could have an impact. This area should be from other equipment and obstacles, which could fall a child, free. Stationary climbing equipment and slides should be a fall zone of at least 6 'in all directions from the size of the equipment. Swings have a fall zone of at least 6 'from the outer edge of the support structure on each side. The fall zone in front and back of the> Swing should be measured a distance of at least twice as high as the swing from the ground than at the top of the swing support structure.
The game area covers an area of 6 'on the swing, made on all sides, including the slide and the space above the swing. The ground surface must be level. Installation on sloping ground can cause them to lean or crack. This brings additional burdens declined for all connections and joints and in the timewill cause those connections to loosen and fail. The play area must be free of all structures, landscaping, trees and branches, rocks, wires, and other obstacles to safe play. Children can be seriously injured running, or swinging into these obstacles. Remove all tripping hazards from the Safe Play Area. Tripping hazards include; roots, stumps, rocks, landscaping, sprinkler heads, railroad ties, plumbing and electrical connections.
แสดงความคิดเห็น